When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Cessna Throttle Quadrant Mixture Carb Heat Flaps Controller for Flight Sims:
$99.00
3D Printing Cessna Throttle - Mixture - Carb Heat - Flaps - controller for flight sims. It is USB and no drivers are needed. Just calibrate in MSFS or Xplane Control Panel, bind controls in game and ready to fly. It uses a Arduino board inside and It is using linear slides and potentiometer.The throttle, and mixture are push-pull only controls. The flap lever is 3 position momentary switch, push up to raise flaps one notch at a time, push down to lower flaps one notch at a time, the switch auto returns to center. The Carb heat it digital switch on off position .The controller work perfectly in Microsoft Flight Simulator 2020 and 2024 and X-Plane and should work in any other flight sims/game as Arduino boards are used in many controllers and regarded as being high quality and very versatile. Includes 6' USB cable, just plug it in and Windows will recognize it without drivers.Dimensions for the case : 200mm x 200 mm x 50mm ,with the Throttle pull out at 350mm x 200mm x 50mm.If you have any issues with the controller please contact me, I will go above and beyond to resolve any issues that may occur. Thank you!
